Datalogic Applications
74 Rhino™ II
3. Click OK to complete.
The added device will display on the left side of the console under
Available Device.
Connect to a Device via Network Using Scan2Pair
These steps assume you already have your network set up, and you
already have your printer set up. To connect a device to a Wi-Fi
access point and to DXU using the default settings, follow the steps
below:
1. Launch
DXU.
2. Click Scan2Deploy on the DXU main window.
3. Enter the SSID and Password for the Wi-Fi access point that your
device will use to connect to your network.
4. Click Print Preview.
5. Click Print in the button bar.
6. Since Print dialog boxes vary by the model of your printer,
configure the print as you normally do. Close these dialog boxes
to exit.
7. Click Start menu > Programs > Device Tools > Scan2Deploy.
NOTE
You can also directly connect the device to DXU using USB.
NOTE
In most cases you should be able to leave other fields
with their default values. You may, of course, change
those values as needed to work with your network setup.
To Next Page
Loading...