ADVANCED CONFIGURATION MODE (SG4-P)
INSTRUCTION MANUAL 35
ESPE Check: user checks if ESPE is working according to SAFETY REPORT (resolution
check with proper test piece, parameters check …)
Figure 3 - Safety report
Password protection and not up to date devices versions compatibility
Starting from release 1.3.0 of SG Extended GUI, firmware version 6.2.0 of SG4-DONGLE,
and firmware version 6.1.0 of SG4 EXTENDED light curtain, an improved configuration
protection mechanism has been implemented by means of a device embedded pass-
word.
For combinations of GUI, SG4-DONGLE and SG4 EXT
ENDED with different versions of
release or firmware, please check the following compatibility table:
R < 1.0.3 - -
Please update to last version of SG Extended
GUI, a
vailable for free at |www.datalogic.com
R ≥ 1.0.3 Fw < 6.2.0 Fw < 6.1.0
During on-line or off-line configuration, system
wi
ll request a GUI password but not a device
embedded password.
R ≥ 1.0.3 Fw < 6.2.0 Fw ≥ 6.1.0
During on-line configuration a device embed-
ded password will be requested.
Off-line configuration is not possible with this
combinat
ion: SG4-DONGLE with Fw ≥ 6.2.0 is
needed.
R ≥ 1.0.3 Fw ≥ 6.2.0 Fw < 6.1.0
During offline configuration, a password will be
r
equested to store the configuration on SG4-
DONGLE, but not transferred to the SG4
EXTENDED.
R ≥ 1.0.3 Fw ≥ 6.2.0 Fw ≥ 6.1.0
System will always request a device embedded
pa
ssword for configuration. It is also possible
to input an empty password.
NOTE
SG
EXTENDED
GUI
RELEASE
SG4-
DONGLE
FIRMWARE
SG4
EXTENDED
FIRMWARE
SG4-DONGLE with Fw version ≥ 6.2.0 reports Fw version on product label.
Otherwise SG4-DONGLE with Fw version < 6.2.0 doesn't report this infor-
mation on product label.
To Next Page
Loading...