USING THE SMART-VS WEBAPP
PRODUCT REFERENCE GUIDE 8
USING THE SMART-VS WEBAPP
Before using a Smart-VS device, a Teaching procedure must be performed. Teaching can
be completed either using the embedded HMI (see
Button Teaching Procedure) or the
Smart-VS WebApp graphic user interface.
To access the Smart-VS WebApp, connect to the device IP address (factory default:
192.168.3.100) via Ethernet.
For systems that support the Link-Local Multicast Name Resolution (LLMNR) protocol,
you can connect to the Smart-VS by typing smart-vs/ in the address bar (if there is only
one device on the network) or smart-vs-[Serial Number]/ (e.g. smart-vs-c12345p/) if
there are multiple devices on the same network.
In case of a new device, the user is automatically redirected to the
Init Page.
If the Teaching procedure has already been performed, the
Monitoring page is displayed.
A
Settings page is also available to adjust the device settings.
Device information and the software update feature are available on the
Utilities page.
Init Page
When connecting a new device, an “Init” page is displayed showing IP and Global Set-
tings:
Under IP Settings, the Address and Netmask fields can be edited to configure any static
IP address, while the Gateway field is optional.
Furthermore, by enabling DHCP, the device automatically acquires the IP address. There
must be a DHCP server in the network. If there is no DHCP server, the device will assign
itself an IP address in the local link range (169.254.0.0/16).
The “Init” page also includes the following buttons to interact with the Smart-VS device:
NOTE: To access the Smart-VS WebApp, Google Chrome is the recom-
mended Internet browser.
To Next Page
Loading...
