DataRemote POTS in a BOX CDS-9010 - 5.3 Network Configuration; 5.3.1 WAN Connection Settings

Copyright © 2019 - All rights reserved by DataRemote Incorporated
V1.0
5.3 Network
You can configuration the WAN port, LAN port, DDNS, Multi WAN,DMZ, MAC Clone,Port Forward and so on in these two bars.
5.3.1 WAN
This page allows you to set WAN configuration with different modes. Use the Connection Type drop down list to choose one WAN mode and then
the corresponding page will be displayed.
Static IP:
You will receive a fixed public IP address or a public subnet, namely multiple public IP addresses from your DSL or Cable ISP service
providers. In most cases, a Cable service provider will offer a fixed public IP, while a DSL service provider will offer a public subnet. If you
have a public subnet, you could assign an IP address to the WAN interface.
WAN IP Mode
The mode for obtain IP address
LAN Connection
Mode
Select to NAT or Bridge
IP Address
Type the IP address
Subnet Mask
Type the subnet mask
Default Gateway
Type the gateway IP address
DNS Mode
Set the DNS Mode from Auto and Manual
Primary DNS
Server
Type in the primary IP address for the route
Secondary DNS
Server
Type in secondary IP address for necessity in
the future