DataRemote POTS in a BOX CDS-9010 - Page 41

Copyright © 2019 - All rights reserved by DataRemote Incorporated
V1.0
Encapsulated Mode
Select the security protocols
NAT Enable
Enable NAT Traversal for IPSec. This
item must be enabled when router
under NAT environment.
Mode
Select from “Main” and “aggressive”
for the IKE negotiation mode in phase
1.
Encryption Algorithm
Select Encryption Algorithm to be
used in IKE negotiation.
Integrity Algorithm
Select Integrity Algorithm to be used
in IKE negotiation.
Diffie-Hellman (DH)
Group
Select Diffie-Hellman Group to be
used in key negotiation phase 1.
SA Lifetime of Phase 1
Set the lifetime in IKE negotiation.
DPD Time Interval(s)
Set the interval after which DPD is
triggered if no IPSec protected packets
is received from the peer.
DPD Timeout(s)
Set the timeout of DPD packets.
Encryption Algorithm
Select Encryption Algorithm to be
used in IPSec SA negotiation.
Integrity Algorithm
Select Integrity Algorithm to be used
in IPSec SA negotiation.
SA Lifetime of Phase 2
Set the lifetime in IPSec SA
negotiation
PFS
Enable or disable PFS. (Perfect
Forward Secrecy)PFS will ensure the
same key will not be generated again