DataRemote POTS in a BOX CDS-9010 - 5.8.4 Device Provisioning Setup

Copyright © 2019 - All rights reserved by DataRemote Incorporated
V1.0
5.8.4 Provision
Please refer to the provision user manual to test provision.
Provision Enable
Select to enable or disable
Resync On Reset
Enable or disable DIV378 Resync after
rebooting
Resync Random
Delay(sec)
Setup the maximum delay for request
synchronization
Resync Periodic(sec)
If the last resynchronization is
unsuccessful, after the "Resync Retry
Delay Error" time, after "time, the
device will retry the resynchronization
Resync Error Retry
Delay(sec)
Set the timed resynchronization
Forced Resync
Delay(sec)
If it is time to re-sync, but the device is
busy, in this case, the device will wait
for some time, the longest is "forced
resynchronization delay", the default is
14400s, time after the device will be
forced to re-sync.
Resync After Upgrade
After the resynchronization, enable or
disable the firmware update function
Resync From SIP
Select to enable or disable resync from
SIP
Option 66
Specifies the TFTP (Simple File
Transfer Protocol) server address
Option 67
Specifies the startup file name
Config File Name
Configure the file name