DataRemote POTS in a BOX CDS-9070 - Page 35

Copyright © 2016 - All rights reserved by DataRemote Incorporated
V1.0
The page 35 of 76
Revision Time: 2016-10-13
DHCP:
It is not necessary for you to type any IP address manually. Simply choose this type and the system will obtain the IP address automatically
from DHCP server.
WAN IP Mode
The mode for obtain IP address
LAN Connection
Mode
Select to NAT or Bridge
DNS Mode
Set the DNS Mode from Auto and Manual,
If user choose manual, you should fill the
primary DNS address and Secondary DNS
address into Primary DNS Address and
Secondary DNS Address.
Primary DNS
Server
Type in the primary IP address for the route
Secondary DNS
Server
Type in secondary IP address for necessity in
the future
PPPoE:
PPPoE stands for Point-to-Point Protocol over Ethernet. It relies on two widely accepted standards: PPP and Ethernet. It connects users
through an Ethernet to the Internet with a common broadband medium, such as a single DSL line, wireless device or cable modem. All the
users over the Ethernet can share a common connection.
PPPoE is used for most of DSL modem users. All local users can share one PPPoE connection for accessing the Internet. Your service
provider will provide you information about user name, password, and authentication mode.