DataRemote POTS in a BOX CDS-9070 - 2 LED Indicators and Connectors; LED Indicators

Copyright © 2016 - All rights reserved by DataRemote Incorporated
V1.0
The page 6 of 76
Revision Time: 2016-10-13
2 LED Indicators and Connectors
Before you use the high speed router, please get acquainted with the LED indicators and connectors first.
2.1 LED Indicators
Front Panel
LED
Status
Explanation
PWR
On (GREEN)
The router is powered on (External Power) and running normally.
On Blinking (GREEN)
The router is powered on (Internal Power - BAT) and running
normally.
OFF
The router is powered off.
SYS
On (GREEN)
System OK
On (RED)
System Fault (SW or HW)
BATTERY
On (GREEN)
Battery Charged
On Blinking (GREEN)
Battery Charging
Red
Battery Low or not connected
Phone 1/2
On (GREEN)
Registered
OFF
Not Registered
WPS
OFF
Not Registered
On (GREEN)
Active for Key registration
WLAN Client
OFF
Non active for Key registration
On (GREEN)
Wireless Client Connected
On Blinking (GREEN)
Wireless traffic (Data)
WLAN AP
OFF
The Wireless Client is powered off or not connected
On (GREEN)
Wireless AP ready
On Blinking (GREEN)
Wireless traffic (Data)
WAN ETH
OFF
The Wireless AP is powered off
On (GREEN)
Connected (Registered)
On Blinking (GREEN)
Connected (Data)
LTE SVC
OFF
Disconnected
On (GREEN)
Connected (Registered)
On Blinking (GREEN)
Connected (Data)
RSSI
OFF
Disconnected
On (GREEN)
Strong