Step 1. Pick up phone and press “****” to start IVR
Step 2. Choose “9”, and CDS-9090 report “ WEB Access Port”
Step 3. Prompt “Please enter password”, the method of inputting password is same as operation 1.
Step 4. Report “operation successful” if user operation properly.
Step 5. Report the current WEB Access Port
Step 6. Set the new WEB access port and with end char #
Step 7. Report “operation successful” if user operation properly.
Notice:
◆ When using Voice Menu, press * (star) to return the main menu.
◆ If any changes made in the IP assignment mode, please reboot the CDS-9090 to take the setting into effect.
◆ When enter IP address or subnet mask, use “*”(Star) to replace “.” (Dot).
For example, to enter the IP address 192.168.20.159 by keypad, press these keys: 192*168*20*159, use the #(pound) key to indicate
that you have finished entering the IP address.
◆ #(pound) key to indicate that you have finish entering the IP address or subnet mask
◆ When assigning IP address in Static IP mode, setting IP address, subnet mask and default gateway is a must. If in DHCP mode,
please make sure that DHCP SERVER is available in your existing broadband connection to which WAN port of CDS-9090 is
connected.
◆ The default LAN port IP address of CDS-9090 is 192.168.1.1 and do not set the WAN port IP address of CDS-9090 in the same
network segment of LAN port of CDS-9090, otherwise it may lead to the CDS-9090 fail to work properly.
◆ You can enter the password by phone keypad, the matching table between number and letters as follows:
⚫ To input: D, E, F, d, e, f -- press ‘3’
⚫ To input: G, H, I, g, h, i -- press ‘4’
⚫ To input: J, K, L, j, k, l -- press ‘5’
To Next Page
Loading...
