DATATRAC 400H Setup Instructions To Clear GPS NVM
Bus setup
1. Press “ENTER” Key
a. SELECT LABEL PAGE #2 page displays
2. On the “SELECT LABEL PAGE #2” page
a. Select “XMT” key
b. Enter values as displayed in the following table:
Note: Page does not contain a title
Use “>” To step through options
Use “^””v” to move to next/previous line
Use Keypad to enter alphanumeric entries
End of Procedure
1. Please refer to Service Information Letter 523-0826445 for complete NVM reset procedure.
To Previous Page
Loading...