49
Stream and Record Settings
In the section, you will be introduced various setting options of stream and record functions.
Bitrate Mode
The bitrate mode sets the video bitrate mode for your video stream.
The available modes are high, mid and low.
Note: You are allowed to switch between different bitrate modes
by pressing the Bitrate button on the Record/Stream panel. See
section 6.4 for details.
Auto Stream
If the Auto Stream is enabled, in the event of power outage, the
stream will be automatically restored after the switcher is powered
ON again.
Resolution
The first step of encoder setup is to adjust the image size. It is best
to either match your original video source or scale it down. For
example, capture at HD 720 and stream at HD 720. Or capture at HD
720 and stream at 540 (high).
You should never be scaling up and streaming at a higher resolution
than your original video source. For example, it does not make sense
to capture at 720 and stream at 1080. Note that you will also have
no gain in quality and you are using more bandwidth than is
necessary for your viewers.
You should also be aware that higher resolutions require greater
processing power to encode the stream. Attempting too high of a
resolution on too little processing power can result in degraded
image quality and corrupted or interrupted streams or recordings.
Frame Rate
Select a frame rate from the drop-down menu for video streaming.
Note that frame rates should always match the frame rate of the
video source.
To Next Page
Loading...
Need help?
General
