Need help?Do you have a question about the David White AutoLaser 3185 and is the answer not in the manual?
General| Type | Rotary Laser Level |
|---|---|
| Accuracy | ±1/8 inch at 100 feet |
| Laser Color | Red |
| Power Source | Battery |
| Self-Leveling Range | ±5 degrees |
| Laser Wavelength | 635 nm |
| Rotation Speed | 0, 150, 300, 600 RPM |
| Laser Class | Class II |
| Battery Type | Ni-MH or Alkaline |
| Dimensions | 6.5 x 6.5 inches |
Guidelines for safe operation, avoiding laser beam exposure, and instrument servicing.
Statement of compliance with federal and CE regulations for laser safety and emissions.
Description of main features and associated icons for the 3100 Series lasers.
Lists various construction and installation projects suitable for the 3100 Series lasers.
Instructions for setting up the laser for general construction using a tripod.
Procedure for installing lasers for ceiling grid applications using a wallmount.
Steps for placing and leveling the instrument in a laydown position.
Instructions for instrument operation, self-leveling, and rotation modes.
Procedures for plumbing and lay-down use on a flat surface.
Adjusting rotation speed for different applications like room-wide references.
Using sweep/scanning for a shorter, brighter laser line for specific tasks.
Creating a laser line between two specified points.
Using Spot Mode for a motionless laser dot as a straight-line reference.
How the instrument handles bumps and self-levels or indicates axis errors.
Troubleshooting for spindle motor rotation or speed errors.
Configuring how the instrument reacts to being moved out of level.
Enabling ADS to detect and signal when the instrument has been moved out of level.
Setting a single axis grade for site grading and excavations.
Disengaging leveling to place the instrument in any position for grading.
Using dual grade for specialized site preparations like road grading.
Using ADS to protect against errors from bumps or settling in Grade Mode.
Adjusting the vertical (plumb) laser line position without moving the instrument.
Steps for replacing low batteries in the laser instrument.
Testing the X-axis accuracy by setting reference points on a wall.
Information on alkaline and rechargeable battery usage, charging, and care.
Detailed steps for calibrating the X-axis for models 3110-GR, 3150, 3150G.
Procedure for testing and calibrating the Y-axis for the 3175 model.
Calibrating X and Y axes for the 3185 model using peg tests.
Testing the Z-axis accuracy in the laydown position for specific models.
Steps to calibrate the Z-axis for models 3150 and 3150G.
Procedure to calibrate the Z-axis for the 3175 model.
Guidelines for cleaning, maintaining, and storing the laser instrument.
Basic tests and checks for common performance failures and errors.
Detailed technical specifications for all 3100 Series laser models.
Details on the two-year warranty, coverage, and contact information.
Introduction to the David White Universal Laser Detector and its uses.
Instructions for powering on and operating the laser detector.
Special features, audio tones, LCD display, and care instructions for the detector.
Guide to using the RC700 remote for models 3150 and 3150G.
Guide to using the RC400X remote for model 3175.
To Next Page
