10
3. Click Test to verify communication.
4. Click OK to save the Communications Port settings.
Note: Leave the BAUD rate at 19200. The console BAUD rate should also be set to 19200.
This is the default setting. See your console User Guide if it needs to be reset to 19200.
WeatherLink SER
1. Select Serial in this
field if you have a
serial data logger,
or are using a USB
data logger and
third party software
that requires
communication via
a COM port.
2. From the drop-
down list, select the
communications
port number of the
port to which you
connected the data
logger, or click
Auto-Detect to
find and select the
correct COM port
being used for your
serial port
connection.
3. Confirm that the
Baud Rate drop-
down list box is
showing 19200 Baud. If it is not, click the drop-down list and select
19200. (Assuming you have not changed the Baud rate on your console.
The two must be the same.)
Note: The console BAUD rate should also be set to 19200. This is the default setting. See
your console User Guide if it needs to be reset to 19200.
4. Click Test to verify communication.
5. Click OK to save the Communications Port settings.
To Next Page
Loading...
Need help?
General
