EasyManuals Logo

DAVIS and Vantage Pro User Manual

DAVIS and Vantage Pro
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
Product Number: 6520
Part Number: 7395.280 Rev. D August 26, 2009
WeatherLink
®
for Vantage Pro, Vantage Pro2, & Vantage Vue, Mac OS X Version
Vantage Pro and WeatherLink, are registered trademarks of Davis Instruments Corp. Vantage Pro2, Vantage
Vue and Weather Envoy are trademarks of Davis Instruments Corp. Hayes is a registered trademark of Hayes
Microcomputer Products, Inc. Macintosh is a trademark of Apple Computer Corporation.
© 2009 Davis Instruments Corp. All rights reserved.
Information in this document is subject to change without notice.
3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A.
510-732-9229 • Fax: 510-732-9188
E-mail: info@davisnet.com • www.davisnet.com
FCC Part 15 Class B Registration Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio commu-
nications. However, there is no guarantee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment on and off, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved in writing by Davis Instruments may void the user’s authority
to operate this equipment.
EC EMC Compliance
This product complies with the essential protection requirements of the EC EMC Directive 2004/108/EC; Low
Voltage Directive 2006/95/EC; and Eco-Design Directive 2005/32/EC> 0.5 watt no-load adapter.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DAVIS and Vantage Pro and is the answer not in the manual?

DAVIS and Vantage Pro Specifications

General IconGeneral
BrandDAVIS
Modeland Vantage Pro
CategorySoftware
LanguageEnglish

Related product manuals