Quick Guide- 18 -
setting for these devices. Hostadapters supplied with a SCSI setup
ignore this parameter and use the setup settings instead.
/PS=.. Specifies the interval (in minutes) after which inactive drives are to be
switched off.
/SN=x,..,x This parameter specifies the devices to be operated in Synchronous
Data Transfer mode if this mode is supported by these devices,
independent of the Windows settings. Entering "/SN=1,4", for example,
enables the synchronous mode for SCSI-IDs 1 and 4. Hostadapters
supplied with a SCSI setup ignore this parameter and use the setup
settings instead.
/!DISC=x,..,x Specifies the devices for which the "disconnect" settings of the
Windows device manager are to be ignored and with it this function is
not available.
To Next Page
Loading...
Need help?
General