Daymak Boomerbuggy - Assembling The Scooter

17
■ Assembling The Scooter
No tools are required to disassemble or assemble your scooter.
1. Push the tiller adjustment knob Set the tiller angle.
2. Pull the Separate Frame safety Lever to unfolded.
3. Put down the front and rear sections until the scooter is level.
4. Pull the seat adjustment lever swivel seat
5. Loosen the tiller adjustment lever and extend the tiller and retighten lever.
6. Turn key switch to “ON”. Make sure battery gauge indicates sufficient power.
4 . O P E R AT I O N
Pull
Toward forward