■ Tires
The condition of the tires depends on how you drive and use your scooter.
Inspecting tire tread
Please check the tread groove regularly. Replace the tires when the tread groove is less than 0.5 mm.
Attention
1. When tread groove is below 0.5mm it can easily lead to scooter slippage, making
braking distances longer. Therefore replace the tires as early as possible when they do
not have insufficient tread depth.
2. When conducting maintenance of your scooter, please turn the power switch to OFF
and remove the charger cords.
Suggestions
Do not splash water directly to wash your scooter as this could lead to malfunction of the system
electrics.
Do not use petrol, solvents or vaporizing solution as these may deform or damage the shrouds.
■ STORAGE
Make sure the scooter is stored under the following circumstances:
- Make sure the seat is set in the “Forward”position
- Make sure the Power switch is turned to OFF
Suggestion
Please store the scooter in a location where it is away from the direct sunlight, rain, or dew. When
storing for a long time, please charge the battery to full power and then disconnect the battery terminal.
For details inquire to your scooter dealer.
■ MOVING ABOUT
Turn the power switch “OFF” before moving.
Lift the scooter by the chassis, and not by the bumpers. Lifting the scooters by the bumper could
cause damage or injury.
For your safety, always ask for help if required. You will need 2 or 3 persons when moving or lifting
the scooter.
To Next Page
Loading...
Need help?
General