The Vienna Electric Bicycle User’s Guide
TPS Training Bulletin
Page 24
Adjusting the EABS Brake Cable Tension
From time to time, you may need to adjust the brake cable tension, to loosen or tighten the
EABS brakes.
On your EABS brakes, a small cable attaches to a nut. Depending on how tightly the cable
is threaded through the nut, the brakes will be tighter or looser.
Just outside the casing, near the drum brake, the brake cable joins the drum brake through
a small wing nut.
This is what the bolt and attached cable look like:
To adjust the brake tension, follow this procedure.
1. Locate the brake lever attached to the wheel.
2. Adjust the 10 MM bolt on the lever of the brake system to the tightness desired.
Warning
Your brakes are a critical safety feature. Do not excessively loosen the
drum brakes. If you do not keep them sufficiently tight, your drum
brakes will fail and your e-bike will not be able to stop properly.
Servicing the Battery
Please consult the special section “The Battery” in this manual for information about
servicing or handling your battery.
To Next Page
Loading...
