To Next PageTo Next Page
Need help?Do you have a question about the Daystrom HEATHKIT HW-29A and is the answer not in the manual?
Details of the transmitter's power input, frequency control, and modulation.
Details of the receiver type, sensitivity, speaker size, audio power, and tuning range.
Details on power rectifier and requirements for internal/external power sources.
Specifications for the included microphone and connecting cables.
Lists the types and quantities of vacuum tubes used in the transceiver.
Provides physical dimensions and weight specifications for the unit.
Explains the operation of the transmitter section, including oscillator and amplifier stages.
Details the receiver's superregenerative detector and RF amplification stages.
Describes the audio driver, output stages, and modulation/output transformer functions.
Explains the internal power supply operation and voltage doubler circuit.
Instructions for attaching the main cabinet and rubber feet.
Steps for installing the microphone connector onto the cable.
Procedure for preparing and connecting the AC power cord.
Wiring instructions for the external power supply cable (12V).
Wiring instructions for the external power supply cable (6V).
Checks for power supply, tube installation, and basic receiver operation.
Steps for testing the transmitter section, including crystal installation and dummy load.
Procedure for receiver alignment using electronic test equipment.
Procedure for receiver alignment using a remote test signal.
Discusses antenna connectors and the use of baluns for transmission lines.
Guidance for installing the transceiver in vehicles, considering antenna placement.
General| Brand | Daystrom |
|---|---|
| Model | HEATHKIT HW-29A |
| Category | Transceiver |
| Language | English |
