Need help?Do you have a question about the Dayton SPA250 and is the answer not in the manual?
RCA jacks for line-level audio sources, stereo to mono conversion.
Allows daisy-chaining of low-level signals to other amplifiers.
Speaker level inputs for connection from full-range amplifier.
Speaker level outputs to pass signal to main L/R speakers.
IEC power jack with integrated fuse holder, supports voltage selection.
Matches amplifier sensitivity to source output for volume control.
Sets subwoofer's upper frequency limit (40-180Hz) for crossover.
Indicates power status (On/Off/Standby) and protection faults (red).
Two-position switch (0°/180°) to compensate for speaker acoustical differences.
Allows selection between 115V and 230V operation, requires fuse change.
Connects amplifier to subwoofer driver with color-coded wires.
Adds +6dB bass boost at 35Hz for enhanced low-end response.
RCA jacks for line-level audio sources, stereo to mono conversion.
Allows daisy-chaining of low-level signals to other amplifiers.
Speaker level inputs for connection from full-range amplifier.
Speaker level outputs to pass signal to main L/R speakers.
IEC power jack with integrated fuse holder, supports voltage selection.
Matches amplifier sensitivity to source output for volume control.
Sets subwoofer's upper frequency limit (40-180Hz) for crossover.
Indicates power status (On/Off/Standby) and protection faults (red).
Two-position switch (0°/180°) to compensate for speaker acoustical differences.
Allows selection between 115V and 230V operation, requires fuse change.
Connects amplifier to subwoofer driver with color-coded wires.
Adds +6dB bass boost at 35Hz for enhanced low-end response.
To Next Page
General