Instruction manual DR2815N BEL VAPOR
dcg16.it
20
3. Installation of spray cup for door/window
First install the spray cup with hairbrush on short spray nozzle
As shown in Figure 4 and Figure 5, install the two small hooks of
the spray cup for door/window onto suspension lugs of the spray
cup with hairbrush, and then trigger the big hook of the spray cup
for door/window, and push the spray cup for door/window up and
clutch it onto the body of the spray cup with hairbrush.
(IV). (V)
Rell water during operation
1. Unplug the power cord and disconnect the power supply
2. Press down the steam button to release the pressure until no
steam is injected out.
3. Slowly unscrew the safety cap but do not remove it, and residual
steam will be discharged slowly until no steam comes out. Then
place the machine in a cool place to cool it down for about ve
minutes. Finally, completely remove the safety cap.
4. Use the funnel and measuring cup to rell a suitable quantity of
cold or hot water into the tank.
5. Re-install the safety cap onto the machine body and tighten it in
position.
After the machine is used
1. After the cleaning machine is used, unplug the power cord and
disconnect the power supply.
2. Press down the steam button to release the pressure until no
To Next Page
Loading...