4) Pour the measured flour into the
mixing bowl.
5) First align the top cover lid card position
with the notch on the front of the mixing bowl
of the fuselage, press down, and install it in
place when you hear a "click".
6) Plug in the power and press the "On/Off"
button, and then press the corresponding
"Auto" button according to the ratio of the
surface. After the stirring is turned, slowly
pour water into the water inlet of the top
cover according to the surface water ratio
reference table.
Note: The water must be poured after the
machine is turned.
7) After about ten minutes, the machine
w
ill give an alarm and the noodle making
will be completed automatically.
Step 1: Cleaning the mixing bowl.
After the dough is air-dried, wipe it with
a cleaning spatula or cloth.
Step 2: After the mixing alex cleans the
dough and air-dry, use a cleaning
spatula to remove the remaining dough.
Step 3: After the disc is air-dried,
place it on the hard panel and pat it
gently, and the dough will fall off
automatically; if there is any residue,
clean it with the metal needle of the
cleaning scraper.
Reminder: After using the noodle maker, do not clean it
immediately. Remove the parts that are i
n contact with the flour,
freeze or leave it to dry before cleaning. It is forbidden to
immerse the body in water or other liquids to avoid leakage
of electricity.
Use method Cleaning method
13
14
4) Versare nella ciotola la farina appena misurata.
indica il corretto posizionamento.
corrispondente alla proporzione dell’impasto.
seguendo le indicazioni riportate nella tabella.
Nota: versare l’acqua dopo aver acceso la macchina.
completerà automaticamente.
To Next Page
Loading...