12
INSTALLATION
First you will need to remove the angle
brackets from the side of the unit and replace
them with cart mount brackets.
Note: grill is shipped prepared for island
installation.
Install the bracket tab on both sides using
eight of the 10-24 x 1/2" screws. Install each
bracket with four screws on each side of
the grill head. For a CAD1-48/48, use the
appropriately labeled bracket for your grill
head and cart side.
1
2
Outdoor appliance head preparation
IMPORTANT!
For the CAD1-48/48 there are two sets of brackets. If you have the
BGB48-BQR, use the brackets labeled LEFT-48 BQR and RIGHT-48 BQR.
If you have the BGB48-BQAR or BE1-48, use the brackets labeled 48-BQAR
3
LPG models only:
Remove the gas compartment drawer for
access to the gas hatch cover. Refer to page
19 for details.
4
Using a Phillips screwdriver, remove the screw
holding the hatch cover in place. Slide the
hatch cover out.
To Next Page
Loading...