8
8
How to Wear
4
5
6
Connect Hand Air Pump to the Air
Valve precisely attaching the Air
Injection Tongs with the Air Valve.
Proceed to slowly use the Hand Air Pump to inate the belt.
Inate the bladder at a rate that is no faster than 1 stroke in each direction
every 5 seconds.
Start with a low pressure (5 PSI) on the rst day and gradually increase to 10 PSI on
the second day and then to 15 PSI on the third day. Recommended usage is 15 PSI
or less depending on your comfort.
Wear for 15-30 minutes. You
can adjust the air pressure at
anytime to your comfort level by
momentarily pressing the Air Valve
to release air.
Release pressure to reach
a comfortable PSI level if
experiencing any discomfort.
Removing DDS: You MUST release the air completely out of the device before removal.
You can do so by unscrewing the Air Valve.
Warning:
Do not inate to 15 psi upon rst application. Never exceed 25 psi.
To Next Page
Loading...