- 47 - 325.6610.17
4.4.2.1.3 Display Mode
Determines how the sensor channels will be shown on the display.
INSTRUMENT
DISPLAY MODE
Available selections are:
• MANUAL
• AUTO
MANUAL MODE: If manual mode is selected, the display will default to
the 4 channel summary mode (refer to section 3.2.2.7). Data for a single
channel may be displayed by selecting the desired channel using the
right and left arrow keys:
Pressing either of these keys enables scrolling through and selecting
the active single-channel displays as well as the 4-channel display.
Selection of a channel will display the selected channel continuously
until a different channel is selected.
AUTO MODE: Automatically scrolls through the available channels,
advancing to the next channel every 3 seconds. In this mode only, the
single-channel displays are shown, the 4-channel summary display is
skipped.
Any selection will automatically revert to the 4-channel summary display
mode during an alarm condition.
4.4.2.1.4 Set Time
INSTRUMENT
SET TIME
Requires numerical entry of the present time in 24-hour clock mode. For
example 1 PM would be entered as 1300. This information is retained
after a power-loss and will not require re-entry.
ENTER TIME AS HHMM
HHMM
4.4.2.1.5 Set Date
INSTRUMENT
SET DATE
Requires numerical entry of the present date in day/month/year format.
ENTER DATE AS DDMMYY
DDMMYY
This information is retained after a power loss and will not require
re-entry. The unit has been designed for compatibility with the year
2000 and will pose no problems when this changeover occurs.
To Next Page
Loading...