325.6610.17 - 52 -
Four possible status indications may occur:
• ABSENT
• BAD
• CHARGING
• FULLY CHARGED
BATTERY STATUS
FULLY CHARGED
Information for this status is updated at several times:
• At power-up
• When exiting SETUP
• Hourly
In normal AC-powered operation, the battery is constantly under charge. Every
hour, on the hour, the unit performs a test of the battery, under load, to determine
its condition and then writes the result to the battery status display.
4.4.2.1.14 Software Version
INSTRUMENT
SOFTWARE VERSION
The SOFTWARE VERSION menu parameter provides a read-only display of the
revision level of the software controlling the Chloralert Plus. Refer to this menu
parameter if there is a need to contact Customer Service with a problem or question.
SOFTWARE VERSION
1.0
The information in this book is based on software version 1.0. Other versions
may not be identical and may have features different from those discussed in this
bulletin. Changes to the software can only be made by replacing the EPROM.
4.4.2.2 Channels
Sensor channel configuration is done using the CONFIGURE-CHANNELS menu.
Configuration menus are shown for channel 1 but configuration data entry for each
sensor channel (1 through 4) is identical. Selecting the number of the channel to
be configured will give access to the menu parameters shown below.
CONFIGURE
CHANNELS
4.4.2.2.1 Tagname
CHANNEL 1
TAGNAME
Allows a unique identifier to be assigned to the system to allow
differentiation between units in multiple-unit installations.
CH1.TAGNAME
NNNNNNNNNN
To Next Page
Loading...