MIOX AE Series Operators Manual
102-00085-E Page 12
Control Panel and Cell Installation
This section provides information and instructions for installing the AE System mounting plate and
electrolytic cell.
Note: these installation instructions do not apply for units that are pre-mounted on a stand.
Mounting Strut
There are three choices for mounting the strut to a wall, depending on the construction of the wall:
1) Wood screws to mount to a stud wall
2) Toggle bolts for a hollow wall such as cinder block or paneling
3) Expansion anchors for concrete
The strut should be mounted to the wall by drilling suitable holes through them. The vertical distances
from the upper to lower strut and the horizontal distances between holes are shown in Figure 2. The
wall material should be of sufficient strength to hold the control panel, which weighs up to 50 pounds
(22.68 kgs).
Figure 2 Strut Bolt Pattern
To Next Page
Loading...