49
SWING GATES
8 Adjustment of operating parameters
If you need to modify the operating parameters (force, speedness
etc..):
1. Scroll down the parameters until you visualize the desire pa-
rameter (i.g. P032);
2. Confirm by pressing on the
key;
3. By pressing on
and , set up the desired value;
4. Confirm by pressing on the
key (display shows the param-
eters previously selected).
For the complete list of the “Operating Parameters” See
the table on page. 66.
9 Programming complete
WARNING At the end of the programming procedure, use the buttons and until the appearance of the symbol “----”, the
operator is now ready again for new manoeuvres.
To perform any “Advanced Programming” operations (cancellation of the remotes, configuration inputs, etc. ..), see
on page 63.
To Next Page
Loading...
