FREESTANDING SPA BATH INSTALLATION & OWNER GUIDE
Manufactured from premium sanitary grade acrylic, Decina’s freestanding spa baths are easy to install, with adjustable self-supporting feet &
can be freely located anywhere in your bathroom. This manual provides the correct steps & care advice for a safe & long lasting installation.
THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED TRADESMAN
READ CAREFULLY
PRIOR TO COMMENCING
INSTALLATION...
PRE-INSTALLATION CHECKS
!
Unpack & check the item is correct & no damage has occurred during transit.
!
If there are any visible defects DO NOT PROCEED WITH THE INSTALLATION & please contact the place of purchase immediately.
ANY CLAIMS FOR DAMAGE WILL NOT BE ACCEPTED AFTER INSTALLATION.
!
Protect your spa bath before & during installation, scratches &/or cracks &/or surface damage sustained during or after the
installation are not covered by warranty.
!
Installation must be in accordance with building regulations & local authority requirements.
!
Electrical installation must comply with AS:3000 - Electrical Wiring Rules.
CARING FOR YOUR SPA BATH
DECINA USES THE HIGHEST SANITARY GRADE ACRYLIC, HOWEVER NAKED FLAMES, CIGARETTES OR STRONG CHEMICALS
SHOULD BE AVOID & REMOVED IMMEDIANTLY. TO PRESERVE THE HIGH GLOSS ACRYLIC SURFACE:
!
When filling the spa bath start with cold water to allow the bath to gradually adapt to the temperature.
!
After using your spa bath clean with a soft cloth & warm soapy water to clean any oils or soap, to prevent tide marks &
preserve the polished surface.
!
Clean using warm soapy water & only mild liquid detergents. Do not use powders, pastes, creams, chemicals, window cleaning
sprays or abrasive cleaners.
!
Cream cleaners may only BE USED to remove stubborn marks.
!
Scratches can be removed with a fine polish like Brasso.
To Next Page
Need help?
General
