Dectron DRY-O-TRON DA2 007 User Manual

Owners Manual DA2 Series Dehumidifier
Dectron, Inc. November 2009 29
Warranty void unless this form
is completed and submitted
within 1 week after startup.
DRY-O-TRON® DA2 Series
Startup Report & Warranty Registration
See unit nameplate for the following information:
Installation Name:
Installation Address:
Dectron Representative Firm:
Supply
Airflow: CFM
Supply Blower
Belt Size (if any)
Unit
Model:
See air-balance report for the following information:
Personally investigate for the following information:
Measured
Airflow (CFM):
Unit
Serial #:
Unit
Ref #:
Adequate service
access provided?
Air supply outlets correct?
Unit level and
vibration isolated?
For ducted units- ducts
per instructions?
For unducted units - minimum 4
feet (1.2m) return-air clearance?
Condensate drain connected
and tested?
Branch-circuit disconnect
installed?
Remote Enable switch
installed?
Crankcase heater working?
Room temperature between
35°F (1.7°C) and 80°F (27°C)?
Wire terminal torques checked?
Compressor service
valves opened?
Air filters clean and in place?
Air heat exchangers clean?
Minimum length of supply-air
duct installed?
Supply-air deflecting vanes
installed and aimed properly?
Air flow and blower speed
adjusted?
Refrigerant sight glass full
while compressor runs?
Actual Values
Temperature of air
entering unit (°F)
Relative humidity of air
entering unit (%)
Temperature of air
leaving cooling coil (°F)
Temperature of air
leaving unit (°F)
Evaporator pressure (PSIG)
Condenser pressure (PSIG)
Compressor discharge-gas
temperature (°F)
Yes
No
N/A
Begin with the unit turned OFF. See safety warnings on a previous page.
Comments:
_____________________________________________________________________________
_____________________________________________________________________________
_____________________________________________________________________________
_____________________________________________________________________________
Form completed by:
Company name:
Date:
Telephone:
Include a copy of the completed and signed four-page Warranty Registration Form.
Attach a copy of the completed and signed air-balance report.
Attach a copy of the completed and signed Pre-Startup Checklist.
Attach any desired further comments or explanatory material. Send all of the above to:
DECTRON INC. DECTRON INC.
4300 Poirier Boulevard 10898 Crabapple Road
Montreal, QC. OR Suite 103
H4R 2C5 Roswell, GA 30075
Canada U.S.A.
Fax: 514-334-9184 Fax: 770-649-0243

Dectron DRY-O-TRON DA2 007 Specifications

General

Brand	Dectron
Model	DRY-O-TRON DA2 007
Category	Dehumidifier
Language	English