11
EN
Fix the power cable with the clip.
The power cable must be long enough to allow
the appliance to be extracted from the cabinet
to fill the coffee bean container.
The appliance must be earthed in compliance
with legislation.
Electrical connections must be performed by a
qualified electrician following the
instructions.
Position the appliance on the rails, making sure
the pins are correctly inserted in the housings,
then fix it with the screws supplied.
If the height of the appliance requires adjusting,
use the spacer disks provided.
If necessary, correct alignment of the appliance
by positioning the spacers supplied under or at
the sides of the support.
Position the rails on the sides of the cabinet as
shown in the figure. Fix with the screws sup-
plied, then extract them completely. If the coffee
maker is installed over a warmer drawer, use the
top surface of this as a reference to position the
rails.
In this case, there will be no surface to rest the
rails on.
To Next Page
Loading...
Need help?
General
