CHANGING THE STRINGS
e following sequence of steps will ensure that the bridge remains in the
correct position and your banjo stays in tune while changing the strings.
We recommend that you lightly mark the position of the bridge in pencil
on the head, in case the bridge falls over or is knocked out of place while
changing the strings. is will save time in the initial repositioning of the
bridge. Refer to the bridge placement section of this manual for specifi cs on
correct bridge placement.
Take one string off . 1.
Rub pencil lead into the nut slot to allow the string to slide more easily 2.
when going into tune.
Re-tune the new string to the other strings on your banjo. 3.
Continue the steps 1 through 3 for each successive string.4.
To Next Page
Loading...