blind fastener and Installation tool does not turn during installation.
Installation of Rope cleat
The two rope cleats are to be mounted where desired.
HEIGHT OF LADDER
Place a ladder on the rack, and check door entry/head clearance. If there is ample clearance, and if desire, the rack legs may be
shortened as long as a minimum clearance of 2” above the cap roof with the ladder is maintained. Remove and cut the legs if
desired.
Note- cut tubing from the bottom of the legs. Double check the measurement before cutting.
WARNING Ladders must be secured per ANSI standard A 14.2-1990 paragraph 8.4.4.ladder damage will occur from road
shock and vehicle vibration if the ladder is not properly secured to the ladder rack. Bouncing and side to side motion of a
improperly secured ladder will cause wear and weaken the ladder. Using a damaged ladder could lead to a structural collapse
and could result in a serious injury or death.
Congratulations on the purchase of this fine Dee Zee Product! Please visit www.deezee.com
for a full line of our
high quality products offered at your local Dee Zee retailer.
DEE ZEE, INC WARRANTY AGREEMENT
Warning:
• Make sure all hardware connections are secure before each use.
• Do not exceed 200 pound weight Limit
• Do not use if restricts your vision or safe driving.
• Always check rack does not un-balance Vehicle in use.
• ALWAYS OBEY ALL LOCAL, STATE AND FEDERAL TRAFFIC LAWS.
• UNDERNOCIRCUMSTANCEESSHOULDTHISPRODUCTBEUSEDTOTRANSPORTPEOPLEORLIVINGANIMALS.
SERIOUSINJURYORDEATHMAYRESULT
• USERISRESPONSIBLEFORTHESAFELOADINGANDUNLOADINGOFTHISPRODUCT.BESURETOUSECAUTION
WHENSTRAPINGDOWNLOADSORLOOSEARTICALES.
To Next Page
Loading...