English
Safety
Precautions
FCC
Statement
This device complies with Part 15
of
the FCC
Rules
.
Operation
is
subject to the
following
two
conditions:
(
1)
This device
may
not cause harmful interference.
(2)
This device must
accept
any
interference
received,
including
interference that
may
cause undesired operation.
CAUTION:
Any
changes
or
modifications not expressly
approved
by
the grantee
of
this device
could
void
the user's authority to operate
the equipment.
Federal
Communitcations
Commision
Interference
Statement
This equipment has been tested
and
found to
comply
with the limits for a Class 8
digital
device, pursuant
to Part 15
of
the FCC
Rules.
These limits are designed
to
provide
reasonable protection
against
harmful
interference in a residential installation. This equipment
generates
uses
and
can radiate
radio
frequency
energy
and
,
if
not
install~d
and
used in
accordance
with the
instructions,
may
cause harmful interference to
radio
communications. However, there
is
no guarantee that
interference
will
not occur
in
a
particular
installation.
If
this equipment does cause harmful interference to
radio
or
television reception,
which
can be determined
by
turning the equipment
off
and
on, the user
is
encouraged
to try to correct the interference
by
one
or
more
of
the
following
measures:
(
1)
Reorient
or
relocate the receiving antenna.
(2)
Increase the separation between the equipment
and
receiver.
(3)
Connect the equipment into
an
outlet on a circuit
different from that to which the receiver
is
connected.
(4)
Consult the
dealer
or
an experienced
radio/TV
technician for help.
RF
Exposure
Warning
This equipment must be
installed
and
operated
in
accordance
with
provided
instructions
and
the antenna(s)
used for this transmitter must be
installed
to
provide
a
separation distance
of
at
least
20
em
from
all
persons
and
must not be co-located
or
operating
in conjunction
with
any
other antenna
or
transmitter. End-users
and
installers
must be
provided
with antenna installation
instructions
and
transmitter
operating
conditions for
satisfying
RF
exposure compliance.
Canada,
Industry
Canada
(IC)
Notices
This Class 8
digital
apparatus
complies with
Canadian
ICES-003
and
RSS-247
Operation
is
subject to the
following
two
conditions:
(
1)
this device
may
not cause interference,
and
(2) this device must
accept
any
interference,
including
interference that
may
cause undesired
operation
of
the device.
Radio
Frequency
(RF)
Exposure
Information
The
radiated
output
power
of
the Wireless Device
is
below
the Industry
Canada
(IC)
radio
frequency exposure limits.
The
Wireless Device should be used in such a manner such
that the potential for human contact
during
normal
operation
is
minimized.
This device has
also
been evaluated
and
shown
compliant
with the
IC
RF
Exposure limits under
mobile
exposure conditions. (antennas are
greater
than
20cm
from a person's body).
5.
15
...
5.25GHz
Band
•
This device
is
operation
in 5 .
15-
5 .
25GHz
frequency
range, then restricted
in
indoor
use
only,
•
Outdoor
operations in the
5150-5250MHz
is
prohibited
.
To Next Page
Loading...
