English
Safety
Precautions
FCC
Statement
This device complies with Part 15
of
the FCC
Rules.
Operation
is
subject to the following
two
conditions:
(
1)
Th
is device may not cause harmful interference.
(2)
This
device must accept
any
interference
received,
including
interference that may
cause undesired operation.
CAUTION:
Any
changes
or
modifications not expressly
approved
by
the grantee
of
this device
could
void
the user's authority to operate
the equipment.
Federal
Communikations
Commision
Interference
Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15
of
the FCC
Rules.
These
limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates
uses
and can radiate
radio
frequency energy
and,
if not installed
and used
in
accordance with the
instructions, may cause harmful interference to
radio
communications. However, there
is
no guarantee that
interference
will
not occur in a particular installation.
If
this equipment does cause harmful interference to
radio
or
television reception, which can be determined
by
turning the equipment
off
and on, the user
is
encouraged to try to correct the interference
by
one
or
more
of
the
following
measures:
(
1)
Reorient
or
relocate the receiving antenna.
(2)
Increase
the separation between the equipment
and
receiver.
(3) Connect the equipment into an outlet on a circuit
different from that to which the receiver
is
connected.
(4) Consult the dealer
or
an experienced
radio/TV
technician for help.
RF
Exposure
Warning
This
equipment must be installed and operated in
accordance with provided instructions
and
the antenna(s)
used for this transmitter must be installed to provide a
separation distance
of
at
least
20
em
from all
persons
and must not be co-located
or
operating in conjunction
with
any
other antenna
or
transmitter. End-users and
installers must be provided with antenna installation
instructions and transmitter operating conditions for
satisfying
RF
exposure compliance.
Canada,
Industry
Canada
(IC)
Notices
This
Class B digital apparatus complies with
Canadian
ICES-003
and
RSS-21
0 .
Operation
is
subject to the
following
two
conditions:
(
1)
this device may not cause interference, and
(2)
this device must accept
any
interference,
including
interference that
may
cause undesired operation
of
the device.
Radio
Frequency
(RF)
Exposure
Information
The
radiated output
power
of
the Wireless Device
is
below
the
Industry
Canada
(IC)
radio
frequency exposure limits.
The
Wireless Device should be used in such a manner such
that the potential for human contact
during
normal operation
is
minimized.
This device has also been evaluated
and
shown compliant
with the
IC
RF
Exposure limits under mobile exposure
conditions. (antennas are greater than
20cm
from a
person's body) .
Caution:
The
device for the
band
5150-5250
MHz
is
only
for indoor usage to reduce potential for harmful interference
to co-channel mobile
satellite
systems. High-power radars
are
allocated
as
primary
users (i.e.
priority
users)
of
the
bands
5250-5350
MHz
and
5650-5850
MHz
and that
these radars could cause interference
and/
or
damage
to
LE-LAN
devices.
To Next Page
Loading...
