PAGE 14 OF19
CONDITION ACTION NOTES AND
COMMENTS
Requires routine cleaning. Mild detergent solution
applied with soft sponge or
cloth. Rinse and wipe dry.
If possible use warm to hand
-hot water. A 5% addition of
ammonia is beneficial.
Finger prints. Pre-treat finger marks with
alcohol or an organic
solvent. Follow immediately
with routine cleaning.
Minimize re-occurrence by
applying a wax or silicone
based household polish to
the clean dry surface.
Wipe with a little baby oil
and a soft lint free cloth.
Buff to shine.
Apply whenever necessary.
Stubborn stains and
Discolouration.
Use a little Ceran cleaning
paste. (available from Defy
Service Centres).
Rinse and dry.
Repeat several times rather
than resorting to a single
aggressive cleaning method.
Grease and fat splatter. Wipe off excess with a soft
cloth or paper towel. Use a
water borne degreasing
agent ( dishwashing
liquid ).Follow up by routine
cleaning.
Scratches on the brushed
finish.
For slight scratches, use a
nylon pad loaded with an
iron-free abrasive polishing
compound. Follow the
direction of the original
texture. Follow up with
routine cleaning.
For deep scratches use a
coarser abrasive initially and
follow up as for light
scratches.
Deep scratches will be
difficult to remove
completely. Do not use steel
wool or metal scourers
unless they are made from
stainless steel.
IT MUST BE APPRECIATED THAT SOME OF THE SUGGESTED PROCEDURES WILL
ALTER THE SURFACE APPEARANCE OF THE TREATED AREA. THEY SHOULD
THEREFORE BE APPLIED WITH DUE CONSIDERATION AND CARE.
To Next Page
Loading...
