Deif CGC 200 - Page 29

1. Press to increase the value of the digit where the cursor is blinking. You can use to de-
crease the value.
2. Press to move to the next digit.
3. When the cursor is on the last digit, press
to enter the access code. The parameter list now
opens.
3. Press or to get to the parameter you want to change.
4. Press to start editing the parameter.
1. Press to increase the value of the digit where the cursor is blinking. You can use to de-
crease the value.
2. Press to move to the next digit.
3. When the cursor is on the last digit, press
to enter the change.
4. After the change is entered, none of the parameter digits will blink. You can now press
or
to get to the next parameter you want to change.
5. When you have finished changing parameters, press to exit parameter setting mode.
The table below lists the functions of the push-buttons in parameter setting mode.
Button Description Function
and
OFF and PAGE DOWN together Enter parameter setting mode
AUTO Increase value, or next parameter
ON Decrease value, or previous parameter
PAGE DOWN Next, or Enter
OFF Exit
CGC 200 installation and commissioning
instructions 4189340806 UK
Commissioning
DEIF A/S Page 29 of 32