3. Display and menus
3.1 Display, buttons, and LEDs
No. Name Function
1 Navigation
Move the selector up and down on the screen.
To see the Event log, push the Up button and the down button at the same time and
hold.
2 Stop
Stops the genset if manual or auto mode is selected.
When you push the button in auto mode, the running mode also changes to manual mode.
2 Configuration
To go to the Configuration menu, make sure the controller is in manual mode, and then push
and hold the Stop button until you see the configuration screen. To go back to manual
mode, push and hold the Stop button.
Push the Start
button to select a parameter and to save the changes you have made.
2 and 1 Programming
To go to the Programming menu, make sure the controller is in manual mode. Then push the
down
button and the Stop button at the same time and hold until you see the
programming screen. To go back to manual mode, push the down button and the Stop
button at the same time and hold.
To see the Event log, make sure the controller is in the Programming menu. Then push the Up
button and the Stop button at the same time and hold until you see the programming
screen. To go back to the Programming menu, push the down button and the stop button
at the same time and hold.
3
Display Graphical
4 Alarm LED The LED is red when there is an active alarm.
5 Start Starts the genset when manual mode is selected.
6 Mode selection Push to change the running mode.
User manual 4189341340A EN Page 17 of 76
To Next Page
Loading...
