No. Function
1 Select the engine type from the drop-down list.
2 Select types of measurements from the engine/ECU.
3 Configure the settings for the ECU communication failure alarm.
4
Configure the settings for the diagnostic lamps on the ECU
• Amber lamp
• Red lamp
• Malfunction lamp
• Protect lamp
See the specific documentation for the engine/ECU for more information.
5
Select the actions that SGC controls for the engine/ECU
• Engine speed
• Engine start/stop
• Engine preheat
6
Configure source addresses for the SGC controller and the engine/ECU.
See the specific documentation for the engine/ECU for information about the source address.
8.3 Generic J1939
Basic information
• Engine controller/type: A controller that uses generic J1939.
• DEIF smart connect: Select Generic J1939.
• Complies with the J1939 standard.
• Baud rate: 250 kb/s
Warnings and shutdowns
These standard warnings and shutdowns are supported:
• EIC yellow lamp
• EIC red lamp
• EIC malfunction
• EIC protection
Alarms on the display
The display can show J1939 diagnostic messages DM1 (active alarms) and DM2 (historic alarm log list). You can
acknowledge these alarms from the display. For some engines, the display has a special alarm display (see the specific
engine type).
Push the Down
button for 4 seconds to see the alarm log. By default, the alarm log shows the DM1 (active alarms). To
see the historical alarm list, use Down
button to select DM2.
xxxxx xx
xxxx xx
xxx xx
xxxxxxxxxxxxxxxxxx
DM1
Alarm log DM1 shows active alarms
Alarm log DM2 shows historic alarms
User manual 4189341340A EN Page 69 of 76
To Next Page
Loading...
