• Use the Up and Down buttons to go through the alarm list.
• oc##: Shows how many times a specific alarm has occurred.
• CLRALL: Push ENTER to clear the entire alarm log list. For safety reasons, this requires the master password.
NOTE If the controller has no translation text for an SPN diagnostic number, Text N/A is shown. For information about
particular SPN numbers, see the engine manufacturer’s documentation. Alternatively, see SAE for a
general description.
Controls to the ECU
Command
Description
Speed The controller writes the configured engine speed to the ECU.
Start/stop The controller writes the start/stop commands to the ECU.
Pre-heat
The pre-heat function is activated when the controller writes this command to the ECU.
The pre-heat output does not need to be configured.
Measurements from the ECU
Command
Description
Lube oil pressure The controller can read and monitor the lube oil pressure from the ECU.
Coolant temperature The controller can read and monitor the coolant temperature from the ECU.
Engine speed The controller can read and monitor the engine speed form the ECU.
Running hours The controller can read and monitor the running hours from the ECU.
Battery voltage The controller can read and monitor the battery voltage from the ECU.
User manual 4189341340A EN Page 70 of 76
To Next Page
Loading...
