6. Configuration mode
6.1 Configuration mode
To configure the controller, follow these steps:
1. Press and hold the Stop/Config button for at least three seconds.
2. The display shows
3. To see the configuration, press the Stop/Config button. To change the configuration, press the Start button.
4. The display shows
5. To enter the the four digit password:
• Scroll through the digits with the Up and Down buttons.
• Select a digit with the Start button.
6. To leave the Configuration mode, press and hold the Stop/Config button.
7. Until the configuration is saved, the display shows
6.2 Configurable parameters
6.2.1 Configurable parameters
The tables give an overview of configurable parameters.
Level 1 (table titles) and Level 2 texts are shown twice:
• DEIF Smart Connect software: Normal sentence case, for example Power on Mode.
• Controller display: Capital case in brackets, for example (POWER ON MODE)
USER MANUAL 4189341227A UK Page 22 of 86
To Next Page
Loading...
