Quick start guide
SIM-Q MKII insulation monitor
Mounting instructions
Use the correct tools for mounting and do not exceed the recommended tightening torques.
CAUTION
Read the instructions
Read these instructions before installation of the insulation monitor, to avoid personal injury and
damage to the equipment.
NOTICE
Warranty
The warranty is lost for products that are damaged due to incorrect tools used for mounting or
excessive tightening of the terminals and screws.
Tools
Use a screwdriver to mount the insulation monitor. Only use two fingers on the screwdriver to make sure you do
not exceed the maximum tightening torque.
You must not use an electrical screwdriver to mount the monitor.
Tightening torques
Terminals
Maximum tightening torques for terminals: 0.5 Nm
Mounting screws
Maximum tightening torques for terminals: 0.5 Nm
3 Quick start guide 4189330019C EN
To Previous Page
Loading...