30
POOL WATER LEVEL
- To ensure optimum safety and the correct operation of the roller, always check that the level of the water in the pool rema-
ins constant and compliant with the manufacturer’s recommendations.
(For further comfort, use an overflow and a level regulator).
- When the level is too high it is caused by the overflow being blocked by leaves or other debris.
- If the water level is too low there is a risk of jamming.
- If there are gutters or hand rails, the pool must be equipped with a water level regulator.
WINTERING
MAINTENANCE
FILTERING
CLEANING (USER’S RESPONSIBILITY)
- Clean your cover fully twice a year (start of season and wintering). This is even more important if you have hard water. To
do this, use a high pressure cleaner with warm water and a descaling product (Décalcit super).
- Also take care to regularly clean the fastening systems and especially the eyebolt so that it never jams. We recommend
lubricating the eyebolts every year for optimum operation.
- It is advisable to inspect the whole system, in the event of abnormal strain on the cover (eg. somebody falling)
- Check the straps annually
-
To obtain the best performance from the solar panels, regularly clean them using a window cleaning product.
- All work must be carried out by a professional who will contact the manufacturer if necessary.
- All spare parts must be original or compliant with the standard.
- Inspect the whole cover for damage/wear and tear.
- At the beginning of each season and in the event of an accident (fall, hail on the cover, abnormal
strain on the cover, etc.) check that the slats have no visible signs of deterioration that could prevent the safe operation of
the cover (cracked, pierced or bent slats, etc.). Change the slats or the whole cover if necessary.
- In both summer and winter, do not cover the slats with an opaque cover. There is a risk of damage due to excess heat.
- Check the condition of the straps (seams) and especially wear on the anti-abrasion sheath. If the latter no longer fulfils its
protective function from friction of the strap against the pool side, replace it.
- The «witness « flashes RED = change the control box battery
- Programme filtering during sunlight periods and operate it
- Winter the pool depending on its geographic location.
- Close the cover in the safety position.
- Leave the batteries connected inside the roller and do not cover the solar panel.
- We recommend you install the IVERNEA winter shield to protect the cover from UVs and dirt
BATTERIES
NEVER COMPLETELY RUN DOWN THE BATTERIES
Connect the batteries to the charger (be careful of the polarity). Plug in the charger. It will turn
on automatically at the suitable voltage and the charging process starts. The red LED indicates
charging. When charging is complete, the red LED turns off and the batteries are supplied using a
maintenance charge. (see charger notice)
Warning: - Keep the charger in a dry place. Never recharge close to the pool, do this in a dry place.
Use
To Next Page
Loading...