Dell EMC BOSS-S1 - Page 13

NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior
of the system.
2 Open the system.
3 Remove the card. See Removing the BOSS-S1 card.
4 Loosen and remove the screw that secures the M.2 SSD module on the card.
5 Lift the M.2 SSD module away from the card.
Figure 5. Removing the M.2 SSD module
1
module connector (2) 2 module (2)
Figure 6. Removing the M.2 SSD module for modular card
1
module connector 2 module
Deploying the BOSS card 13