Steps
1. Remove the (M2x3) screw that secures the hard-drive assembly to the chassis.
2. Turn the hard-drive assembly to access the hard-drive cable.
3. Open the latch and disconnect the hard-drive cable from the connector on the system board.
4. Carefully unroute the hard-drive cable from the routing guide on the chassis.
NOTE:
Observe the routing of the hard-drive cable inside the chassis as you remove them. Route the cable properly
when you replace the component to prevent the cable from being pinched or crimped.
5. Remove the hard-drive assembly.
Installing the hard-drive assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
15
To Next Page
Loading...
