About this task
The figure indicates the location of the hard-drive assembly module and provides a visual representation of the installation
procedure.
Steps
1. Place the hard-drive assembly on the cover.
2. Route the hard-drive cable through the routing guide on the chassis.
3. Connect the hard-drive cable to the connector on the system board and close the latch to secure the cable.
4. Turn the hard-drive assembly module and align the tabs on the hard-drive assembly with the slots on the chassis.
5. Align the screw hole on the hard-drive assembly with the screw hole on the chassis.
6. Replace the M2x3 screw to secure the hard-drive assembly to the chassis.
Next steps
1. Follow the procedure in after working on your device.
16
Removing and installing components
To Next Page
Loading...
