Installing the memory module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the memory module and provides a visual representation of the installation procedure.
Steps
1. Lift the absorber above the memory-module slot, and align the notch on the memory module with the tab on the memory-
module slot.
2. Slide the memory module firmly into the slot at an angle.
3. Press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
4. Lower the absorber above the memory module.
24
Removing and installing components
To Next Page
Loading...
