Table 2. Antenna-cable color scheme (continued)
Connectors on the wireless card Antenna-cable color
Auxiliary (black triangle) Black
2. Align and place the WLAN card bracket to secure the WLAN antenna cables to the WLAN card.
3. Align the notch on the WLAN card with the WLAN connector and insert the WLAN card at an angle into the WLAN card slot.
4. Replace the (M2x3.5) screw to secure the WLAN card to the system board.
Next steps
1. Install the cover.
2. Follow the procedure in after working on your device.
Internal solid-state drive
Removing the solid-state drive
Prerequisites
1. Follow the procedure in before working inside your device.
2. Remove the cover.
About this task
The figure indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the removal
procedure.
Removing and installing components
27
To Next Page
Loading...
