Steps
1. Connect the system fan cable to the connector on the system board.
2. Align the tabs on the system fan with the guiding rails on the heat-sink bracket.
3. Press the system fan down into the fan tray until it clicks into place.
Next steps
1. Install the cover.
2. Follow the procedure in after working on your device.
Power button
Removing the power button
Prerequisites
1. Follow the procedure in before working inside your device.
2. Remove the cover.
3. Remove the system fan.
About this task
The figure indicates the location of the power button and provides a visual representation of the removal procedure.
Removing and installing components
33
To Next Page
Loading...
