Steps
1. Disconnect the power-button cable from the connector on the system board.
2. Unroute the power-button cable from the routing guide.
NOTE:
Observe the routing of the power-button cable inside the chassis as you remove them. Route the cable properly
when you replace the component to prevent the cable from being pinched or crimped.
3. Remove the (M2x3) screw that secures the power button to the chassis.
4. Lift the power button out of the chassis.
Installing the power button
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power button and provides a visual representation of the installation procedure.
34
Removing and installing components
To Next Page
Loading...
